Synchronous belt wheel factory tell us in the belt wheel application should pay attention to some problems. First, when the pulley speed is greater than the speed limit, must be balanced, when the speed is less than the speed limit, just as static balance.
Synchronous belt wheel factory tell us it should not greater than the permissible value after balanced detection. Synchronous belt wheel factory say that in the pulley installation skew, the belt is pressed against the stop plate side, resulting in increased wear and tear with sides. Therefore, synchronous belt wheel factory tell us must be careful when installing the pulley axis parallel, so that the center plane of the drive pulleys are in the same plane.
According to synchronous belt wheel factory, overload or preload is too large will lead pitch poor, resulting in interference engagement with tooth wear, overload, bearing capacity dropped significantly. Therefore, timing belt applications must prevent overload, and select the appropriate preload.
