Synchronous belt wheel manufacturer suggests all of the operators need to keep a habit to check the current tightness degree of the Synchronous belt, and adjust it to according to the standard requirement. Because Synchronous belt wheel manufacturer said if the Synchronous belt is too loose, then it would very easy to has the slipping problem, it also causes the synchronous belt has the worse abrasion problems, and the transmission power even can’t be transmitting. And Synchronous belt wheel manufacturer attention if the tightness degree is too tighten, the Synchronous belt would be draw out and has the deformation damages.
So Synchronous belt wheel manufacturer said the right check method is to put your hands on the center part of each synchronous belt and add about two kilograms vertical pressure, and the total deflection volume between twenty to thirty millimeters is the best, and if the tightness degree is still not suitable,they need to re-adjust it in time.