When belt running ,the belt wheel axle angles formed or there is toothed wheel taper exist in the processing . Synchronous belt wheel manufacturers say that owing to the uneven load applied to the belt,there will be uneven squeeze between toothed wheel.Belt failure often begins from the cracks at the tooth root or from the carrier's largest belt ,and the tension began to tear the side and extended to the entire belt width, which result in the belt tooth shear. Synchronous belt wheel manufacturers tell us because of the relatively large fiber tension, the belt squeezing serious side may also appear significant wear, and may climb out or roll belt pulley ribs place.
When the belt is running on the not paralleled belt wheel, if the belt is squeezed between two opposing flanges, the sides of the belt can cause severe wear. Synchronous belt wheel manufacturers say in this case, the belt will crack or tear from both sides of the tooth root. This tear will eventually extend to the entire belt, causing the belt tooth shear. Belt or tooth surface fatigue strength will eventually lead to premature failure of the belt.